Total system runout TIR ≤3 μm @ 3 x D

Our holistic system consists of a powRgrip colletholder and collet. All components together ensure best runout and accuracy.

 Colletholder runout TIR ≤1 μm

Measured from collet cavity to outer taper.

 Surface finish max. Ra 0.25

Achieve high clamping force and high transferable torque.

 ID chip hole (only HSK form A)

In accordance with DIN 69873 for 10 mm diameter.

Balancing

100% balanced G 2.5 @ 25,000 rpm/<1gmm.

XL colletholders

100% balanced to G 2.5 @ 5,000 rpm.

 Hi-Q balancing system

REGO-FIX HSK / PG colletholders are balanced to G 2.5 @ 25,000 rpm. Type H colletholders are ready to accept Hi-Q balancing rings which allow precisionbalancing of the system including cutting tool up to 80,000 rpm depending on the balancing rings used.

 Vibration dampening

Our holders offer a good vibration dampening to sustain a high surface finish and can prevent cutting force alterations.

 Matched tooling system for best fit

For highest precision and best results the entire machining system counts. Therefore our components are carefully matched for optimum fit and accuracy. This guarantees the best runout and balance.